2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 164
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Note:
* This system is serviced as a kit (seat foam, module and/or sensing mat). Perform a Passenger Presence System Preload procedure whenever a
component is replaced. Refer to Passenger Presence System Preload Test (See: Restraints and Safety Systems/Air Bag Systems/Description
and Operation/Passenger Presence System Preload Test).
* Both SDM and Passenger Presence Module set DTC B0081 but with different symptom bytes. Therefore it is important to identify which
module has set the DTC B0081. Use the symptom bytes as a way of identify the correct module to diagnose.
1. Verify that DTC B1001 is not set in the SDM.
瀚慖f the DTC is set in the SDM, refer to DTC B1001 (See: B Code Charts/B1001/Supplemental Inflatable Restraints).
2. Verify that DTC B0074, B101D, or B101E is not set in the passenger presence module.
瀚慖f any of the DTCs are set in the passenger presence module, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic
Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).
Note: The SDM sets a redundant B0081 00 DTC when the passenger presence module sets a DTC B0081 11 or B0081 4B.
3. Verify that DTC B0081 00 is not set in the SDM
瀚慖f DTC B0081 00 is set in the SDM, then the passenger presence module has set a B0081 11 or a B0081 4B. Refer to B0081 (Passenger
Presence Module) for diagnosis.
Note: The SDM sets a B0081 3A when an incorrect passenger presence module is installed.
4. Verify that DTC B0081 3A is not set in the SDM.
瀚慖f DTC B0081 3A is set in the SDM, replace the K85 passenger presence module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for passenger presence module and SDM replacement,
setup, and programming
Passenger Presence Detection Module
DTC B0081 (Passenger Presence Detection Module)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B0081 11
- Passenger Presence Module High Input
