Monday, April 27, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 263

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 263



Action Taken When the DTC Sets



The heated seat function for both rear seats will be disabled.



Conditions for Clearing the DTC



* The current DTC will clear and set a history code 3 seconds after the reference voltage returns to normal operating range and the ignition is



cycled OFF then back to ACC or RUN.



* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.



Reference Information



Schematic Reference



Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Rear Heated Seats Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Rear Heated



Seats)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the X2 harness connector at the K29R rear seat heating control module.



2. Test for infinite resistance between the control circuit terminal 3 and ground.



瀚慖f not the specified value, test the control circuit for a short to ground.



3. Test for infinite resistance between the control circuit terminal 5 and ground.



瀚慖f not the specified value, test the control circuit for a short to ground.



4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.



瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.



5. Verify that a test lamp does not illuminate between the control circuit terminal 5 and ground.



瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.



6. If all circuits test normal, replace the K29R rear seat heating control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for rear seat heating control module replacement, setup,