2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 672
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Observe the function of the right and left turn signal lamps while turning the hazard lamp switch ON and OFF. The right and left turn signal lamps
should cycle ON and OFF while the hazard lamp switch is ON and remain OFF when the hazard lamp switch is OFF.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the P17 info display module.
2. Ignition ON, test for greater than 10V between the signal circuit terminal 16 and ground.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K9 BCM.
3. If all circuits test normal, replace the P17 info display module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Radio Control Assembly Replacement (See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Radio/Stereo/Service
and Repair/Radio Control Assembly Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming
B3604
DTC B3604 or B3605
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B3604 02
- Adjustable Pedal Forward Switch Circuit Short to Ground
DTC B3605 02
- Adjustable Pedal Rearward Switch Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
Ground is supplied at all times to the adjustable pedal switch. When the pedals switch is pressed, a 5 V reference voltage is applied through the
switch contacts and the switch signal circuit to the memory seat control module. The memory seat control module then commands the adjustable
pedals motor to move in response to the switch signal.
Conditions for Running the DTC
The memory seat control module must be powered.
Conditions for Setting the DTC
The forward and rearward switch signal circuits are active at the same time.
