Sunday, May 24, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 615

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 615



Circuit/System Description



With each press of a keyless entry transmitter button, a message containing the current battery state of the transmitter is sent to the remote control



door lock receiver, along with the commanded keyless entry function. The remote control door lock receiver sends this to the body control module



(BCM) to perform the requested function.



Conditions for Running the DTC



A keyless transmitter button is pressed.



Conditions for Setting the DTC



3 consecutive low battery signals are received from the same transmitter.



Action Taken When the DTC Sets



The keyless entry system is inoperative.



Conditions for Clearing the DTC



The DTC is cleared when a normal transmitter voltage signal is received from the transmitter that set the DTC.



Reference Information



Schematic Reference



Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry



Transmitter/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Keyless Entry System Description and Operation (without ATH) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless



Entry/Description and Operation/Keyless Entry System (without ATH))Keyless Entry System Description and Operation (with ATH) (See:



Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System (with ATH))



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Verify none of the following DTCs are set:



* DTC B3109



* DTC B3110



* DTC B3111



* DTC B3112



* DTC B3113



If any of the DTCs are set, replace the battery in the appropriate keyless entry transmitter. Operate the transmitter 3 consecutive times. If the DTC



resets, replace the keyless entry transmitter.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Replacing Keys (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and Repair/Replacing Keys)